Renderoc FC is designed for vertical and overhead use toinfill honeycombing and voids up to 3 mm deep in the surface of concrete which is not trafficked and is subsequently coated.
Renderoc FC is supplied as a ready to use blend of dry powders requiring only the site addition of clean water to produce a highly consistent cementitious fairing mortar. The material is based on a blend of cements, graded aggregates, special fillers and chemical additives to providea material with good handling characteristics, while minimising water demand.
The product exhibits excellent thermal compatibility with concrete and is fully compatible with other Renderoc mortars and Dekguard coatings.
Renderoc FC is designed for application in thin layers to produce a fair-faced appearance to concrete surfaces or masonry surfaces in readiness to receive a protective/ decorative coating. Surface imperfections up to 3mm in depth can be filled with the scrape-coat application. Voids of greater depth should be separately filled as a prior operation, again limiting the material thickness to 3mm. Alternatively, consideration should be given to the use of Renderoc RP252 reprofiling and protection mortar. Where higher compressive strengths and low permeability characteristics are required, Renderoc RP 252 or Renderoc ST05 should be used.
Renderoc FC can also be used in association with other Renderoc mortars.
Renderoc FC is suitable for repair method 3.1 as defined by BS EN 1504-3.
Product code : 84FRRF
Nationwide Delivery
